Loading... Loading...
Use the lift tools envisaged in this usage
- Suction lifter for smooth surfaces
- Clamp for panel with carpet or fitted carpet
Never use screwdriver or lever
It is recommended to disassemble panels in draughtboard.
A location of panels of sides witch must be desassembled is necessary in order to put them back in the same place.
Check the good positioning of the gaskets and eliminate all foreign bodies on pedestals and stringers.
Replace panels carefully in the same sense and, if possible, in the same order as in taking down by raising the adjacent panel lightly to close again easily.
The moving of heaving loads will have to be made on ways of reinforced temporary, in order to divide the loads and safeguard the covering against the stamping.
- To wash in big water
- To use barely spun rag
- Top keep covering dry after cleaning
- To use abrasive stamps on laminates
- To use products based on organic solvent on vinyl coverings
Laminates :
A good suction or a simple passage of a lightly humid rag is enough in general
Homogeneous vinyl :
Maintenance will be easier if the surface was enriched with habitual product at the beginning of the implementation of the rooms.
Daily maintenance :
A good suction or a simple passage of a lightly humid rag is enough in general.
Pickling and protection :
By mono-brush, any recognised detergents or agreed strippers.
Be carefull, the application of certain polished waxes cancels the antistatic characteristics of the covering.
In any case, refer to the advices of maintenance of the manufacturer of the coverings.
